Alkaline battery research is increasing. An electrochemical cell that can be used with alkaline solutions or solutions that attack glass was needed.

The following selections are made for the combination of cells for alkaline solution measurement

1 Teflon cells with 100ml, 150ml and 200ml capacities
2 6.1414.010 cell cap
3 Alkali+Joint Alkaline reference electrode & joint
4 PtC 1 x 30 platinum wire counter electrode
Or his counter electrode holder and GC, platinum load
5 6.2026.010J Cell fixing base
6 6.1440.010J Gas purge tube
7 Working electrode

Teflon cell 20-100ml

The cell has a height of 80 mm and an outer diameter of 78 mm, and can be electrochemically measured in the range of 20 ml to 100 ml solution volume.

Price USD/EUR 128

Teflon cell 50-150ml

The cell has a height of 80 mm and an outer diameter of 78 mm, and can be electrochemically measured in the range of 20 ml to 100 ml solution volume.

Price USD/EUR 128

Teflon cell 70-200ml

The cell has a height of 80 mm and an outer diameter of 78 mm, and can be electrochemically measured in the range of 20 ml to 100 ml solution volume.

Price USD/EUR 128

Platinum wire counter electrode (wire diameter 1 mm, length 30 cm)

Made of 99.99% platinum wire with 1mm diameter and 30cm length. Teplon joints match cell caps (6.1414.010).

Price USD/EUR 398

The cell cap is made of chemical-resistant polyphenylene sulfide resin (PPS) and has five holes. The hole diameter (joint) is SGJ 14/15. , the center hole is often used for Autolab rotating disk electrodes. Since each electrode is inserted obliquely into the surrounding hole, air bubbles at the tip of the electrode can be easily removed. The unused holes are sealed with a sealing sleeve (something like a cap). There is a com ring for sealing at the back of the cell cap.